I have a 2014/15 model pro-force electric golf trolley. It works on the pre-set a,b,c fixed distances fine but doesn’t work on the Manual mode. The numbers still go up and down when the knob is turned but no movement. The screen seems fine, it’s had a new knob so does that mean it will need a new control module? Cheers



With you saying it has a new speed control switch then this makes it more difficult to say where the fault lies.  Normally it would definitely indicate the problem lies with the speed control switch or its connections.  The first task would be to make sure the speed switch is properly fitted; connections all connected properly and no dirt inside the connector plug and that the switch itself is working.  So assuming the speed switch is working and connected OK the control box or LED handle circuit board (PCB) can cause some strange issues as does the control module.  Although you can’t rule out the control box module completely, my best guess would be more to do with; firstly the golf trolley speed control switch then secondly the LED circuit board in the handle.  Sorry I can’t be of more help, but without having tested the golf trolley, this would be my best diagnoses of the fault.


  1. Comment by Peter

    Peter Reply 6th January 2017 at 15:50

    I have the same trolley with a similar problem except mine either goes on 7 or stops on 0 depending on how it feels. I have cleaned the controller etc with no obvious improvement. I suspect the potentiometer under the control knob. Are spares available?

  2. Comment by Paul Gurney

    Paul Gurney Reply 28th January 2017 at 20:15

    I have the same trolley but when mine gets to 7 it continuously flashes but don’t go as fast as it should

  3. Comment by Paul Gurney

    Paul Gurney Reply 28th January 2017 at 20:16

    Does anyone know what this problem could be

    • Comment by support

      support Reply 29th January 2017 at 22:41

      Flashing number normally means it’s not getting the current it needs but if the battery and lead is ok it sounds like the controller. Make sure the motor does not have a burnt smell either.

Leave a Reply to support Cancel reply

Your email address will not be published. Required fields are marked *

Go top